Operating Instructions
Instructions de fonctionnement
Humidifier
The operating mode can be defined when the unit is ‘On’ or in ‘Standby’. The following steps are provided assuming the unit is in standby mode.
1)Open the upper rear panel and locate the internal reser- voir fill cap. Proceed to remove the fill cap (fig E.) from the reservoir.
2)Slowly fill the internal water reservoir with fresh clean
water until the Water Level Display illuminates all four status bars to signify the tank is full (as shown in Fig G).
3)Replace the fill cap and close the upper rear panel. If you have removed the water tank during the fill process ensure that the handle on the internal reservoir has been returned to it’s original position - flat against the bucket.
4)Depress the ‘Mode’ button on the control panel until the Humidifier icon is displayed in the LCD screen (Fig H).
5)Select the desired humidity level from 35% RH ~ 80% RH
by depressing either the increase () or decrease ()but- tons on the control panel. To select continuous as the mode of operation in lieu of defining a precise humidity level, press the increase or decrease button until see the “ - - “ in the set humidity display portion of the LCD, as shown in Fig. I.
6)Depress the power button to start the unit in Humidifier mode at your specified settings.
Please note: During the Humidifier mode, the fan speed cannot be changed.
| Fill Cap |
Fig E |
|
MODE | 3 |
| |
Full | _ |
|
Fig G
MODE |
Fig H |
39RH% ºF
ºC
__ RH%
Identification des |
|
|
|
pièces |
|
|
|
1 | 2 |
|
|
3 | 4 | 6 | 7 |
|
| ||
|
|
| 8 |
| 5 |
|
|
1. Panneau Supérieure |
| 5. Roulettes |
|
2. Panneau De Commande Électronique |
| 6. Réservoir Interne |
|
3. Poignée |
| 7. Poignée Du Réservoir Interne |
|
4. Panneau de façade (amovible) |
| 8. Bouchon de remplissage |
|
Fig I
10 | 19 |
