Danby DKC146SLDB Beer Keg Installation Instructions, ELECTRICAL CONNECTION cont, Metal Washers

Installation Instructions

ELECTRICAL CONNECTION (cont)

This Beer Dispenser requires a standard 115/120-volt, 60Hz electrical outlet with three-prong ground receptacle. The cord should be secured behind the Beer Dispenser and not left exposed or dangling to prevent accidental injury.

Never unplug the Beer Dispenser by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle.

WARNING

CO2 GAS CAN BE DANGEROUS

CO2 cylinders contain high-pressure compressed gas which can be hazardous if not handled properly. Make sure you READ and UNDERSTAND the following procedures for CO2 cylinders

BEFORE INSTALLATION.

1.ALWAYS connect the CO2 cylinder to a regulator. Failure to do so could result in explosion with possible injury when the cylinder valve is opened.

2.NEVER connect the CO2 cylinder directly to the product container.

3.ALWAYS follow correct procedures when cylinders are changed.

4.ALWAYS secure the cylinder in an upright position.

5.NEVER drop or throw a CO2 cylinder.

6.ALWAYS keep a CO2 cylinder away from heat. Store extra cylinders in a cool place (preferably 70°F). Securely fasten with a chain in an upright position when storing.

7.ALWAYS ventilate and leave the area immediately if CO2 leakage has occurred.

8.ALWAYS check the D.O.T. test date on the cylinder neck before installation. If over five (5) years, do not use, return cylinder to gas supplier.

9.NEVER connect a product container unless there are two (2) safety’s in the pressure system:

a.One at or on the CO2 regulator

b.One at or on the product coupler or in the pressure gas line.

Beer Keg Installation Instructions

Keg Installation Sketch

SINGLE GAUGE	FAUCET ASSEMBLY
PRESSURE
REGULATOR	TOWER
TOWER
	CLEAR HOSE
	WITH WING NUT
	AMERICAN
	SANKEY TAP
	KEG
CO2 TANK

•Install the four castors with lock provided into the unit’s bottom (four screw holes pre-supplied) The two metal gaskets are used for the front two Castors. Figure (1) before installation. Figure (II) is the final version.

METAL

WASHERS

RED PRESSURE HOSE	Figure 2
Figure 1

7