INSTALLER CHECKLIST/BURNER ADJUSTMENTS
INSTALLER FINAL CHECKLIST:
❏ Specified clearances main - | ❏ Air shutters adjusted. | ❏ Unit tested and free of leaks. | |
tained to combustibles. | ❏ Adjustable low setting satis- | ❏ User informed of gas supply | |
| |||
❏ Nylon straps removed from | factory. | ||
burners. | ❏ Drip pan in place properly |
| |
|
| ||
❏ All internal packaging | and sliding freely. | PLEASE LEAVE THESE | |
removed. |
| ||
❏ Pressure regulator | INSTRUCTIONS WITH THE | ||
| |||
❏ Knobs turn freely, bezels | connected and set for 4.0" | USER. | |
centered. | W.C. Natural, 11.2" W.C. LP | USER, PLEASE RETAIN | |
| gas. | ||
❏ Each burner lights satisfa- | THESE INSTRUCTIONS | ||
| |||
torily, individually or with | ❏ Manual | FOR FUTURE REFERENCE. | |
adjacent burner lit. | installed and accessible. |
| |
|
|
|
GRILL BURNER FLAME HEIGHT:
To access the grill burner air shutters first remove the valve panel by removing the four screws on the corners of the valve panel. Remove the control knobs. Pull the valve panel outward while unplugging the igniter. With a screw driver, loosen the
BURNER AIR ADJUSTMENT:
Each grill burner is tested and adjusted at the factory prior to shipment; however, variations in the local gas supply or a conversion from one gas to another may make it necessary to adjust the burners. The flames of the burners (except the rotisserie burner) should be visually checked and compared to that of the drawing in Fig.07. Flames should be blue and stable with no yellow tips, excessive noise or lifting. If any of these conditions exist, check if the air shutter or burner ports are blocked by dirt, debris, spider webs, etc. Proceed with air shutter adjustment. The amount of air which enters a burner is governed by a sheet metal cup or disk at the inlet of the burner called an air shutter. It is locked in place by a set screw which must be loosened prior to lighting the burner for adjustment.
WARNING: IMPORTANT!
Before lighting, inspect the gas supply piping or hose prior to turning the gas "on". If there is evidence of cuts, wear, or abrasion, it must be replaced prior to use.
TO ADJUST:
3/8"
1/2"
1.Be careful as the burner may be very hot.
2.If the flame is yellow, indicating insufficient air, turn the air to the burner.
FIG. 07 Burner Flame Height
airshutter counterclockwise to allow more
3.If the flame is noisy and tends to lift away from the burner, indicating too much air, turn the air shutter clockwise.
4.Once adjusted turn the burner off and reverse steps to reassemble.
13
