USING THE GRILL
LIGHTING INSTRUCTIONS
BEFORE USING YOUR GRILL, CHECK THAT ALL PACKAGING HAS BEEN REMOVED.
TO LIGHT THE GRILL BURNER:
Open the grill hood and/or remove the top grate cover from side burner (for 48BQR) before lighting. Turn all knobs to “OFF”. Turn the main gas supply on slowly. If you smell gas, shut off gas supply and call for service.
Push and hold the ignition button, turn the selected burner knob to “SEAR”. If burner does not light in 4 to 5 seconds, turn knob “OFF” and wait 5 minutes before trying again to
allow for any accumulated gas to dissipate.
Grill Match Lighting:
If the burner will not light after several attempts then the burner can be match lit. If you’ve just attempted to light the burner with the ignition, allow 5 minutes for any accumulated gas to dissipate. Keep your face as far away from the grill as possible and hold and
pass a lighted match over the hole located on the top left for burn- FIG. 30
er on the left, or the right hole for the right burner (Figs. 30, 31, and 32). Push and turn the control knob which is centred on the burner where the lit match is located, to “SEAR”. If the burner does not light in 4 seconds, turn the knob off, wait 5 minutes and try again.
Once the left or right burner is lit, the adjacent burner can be lit by the
FIG. 31
FIG. 32
NOTE:
In certain types of LPG cylinders, improper lighting procedures can cause the LPG cylinder flow control to activate, resulting in reduced heat output. If this is suspected, to reset flow control, shut off all burner controls and LPG cylinder valve, wait 30 seconds, then turn LPG cylinder valve on extremely slowly, wait five (5) seconds and push and hold the ignition button and turn burner valve on to “SEAR”.
TO LIGHT SIDE BURNERS (48BQR MODELS ONLY):
CAUTION!
The side burner cover may be hot if the grill burners are in operation.
Side Burners Lighting Instructions:
First remove the burner cover and any cooking utensils from the burner grate. Push and hold the ignition button, turn the control knob to the “HI” position until the burner is lit or 4 seconds pass. If the burner doesn’t ignite, wait 5 minutes for any accumulated gas to dissipate then try again. If the burner will not light after several attempts, section ‘Troubleshooting’.
Control Knobs | Ignition |
FIG. 33
Side Burners Match Lighting:
Hold a lighted match near the burner ports, turn the control knob anticlock-
wise to “HI”. Move your hand immediately once the burner is lit. Rotate the control knob to the desired setting.
Note:
If you are using propane gas, a slight pop or flash may occur at the burner ports a few seconds after the burner has been turned “off”. This “extinction pop” is normal for propane gas.
Cap
FIG. 34
Side burners:
The burner should never be operated if the cap is not in place (Fig. 34).
24
