Definitive Technology 4000, 6000 owner manual 8Connection & Setup, Lfe Input, Line In, english

8Connection & Setup

There are four options for connecting your subwoofer:

RECEIVER

RECEIVER

RECEIVER

PREAMP OUT

english

1	LFE INPUT		2	LINE IN
	1A (This method is recommended for home theater systems with receivers that			(best for systems with no LFE/sub-
	do not allow low-pass filter [crossover] and high-pass filter frequencies to be set			woofer output jack such as 2-chan-
	independently. It uses the low-pass filter built into the receiver and bypasses the			nel systems)
	one built into the subwoofer.)			1.	Power-off the amplifier/receiver
	1.	Power-off the amplifier/receiver and disconnect the subwoofer from the AC		and disconnect the subwoofer from
	socket.			the AC socket.
	2.	Connect a standard RCA cable from the subwoofer/LFE output of your receiver		2.	Connect standard RCA cables
	to the LFE input of the SuperCube subwoofer.			from the front L&R pre-out jacks of
	3.	Connect the subwoofer to an AC power source and turn it on (see page 7).		the receiver.
	4.	Turn on the receiver’s power and access the “speaker setup” or “speaker		3.	Connect the subwoofer to an AC
	configuration” menu.			power source and turn it on (see
	5.	Set the subwoofer to “Yes” or “On”.		page 7).
	6.	Select the crossover frequency that is appropriate for your main front		4.	If the system is 2-channel, skip to
	loudspeakers (see chart on page 18).			step 8.
				5.	If the receiver is a multi-channel
	1B (This method is recommended for home theater systems with receivers that			device, turn on the receiver’s power
	allow low-pass and high-pass filters [crossovers] to be set at different frequencies.			and access the “speaker setup” or
	This method uses the low-pass filter built into the subwoofer rather than the one			“speaker configuration” menu.
	built into your receiver as the LPF in the SuperCube is better and more convenient			6.	Set the subwoofer to “None” or
	to adjust as you are listening to program material.)			“Off”.
	1.	Power-off the amplifier/receiver and disconnect the subwoofer from the AC		7.	Set front L&R speakers as
	socket.			“Large”.
	2.	Connect a standard RCA cable from the subwoofer/LFE output of your receiver		8.	Start with the volume set to V25.
	to the LFE input of the SuperCube subwoofer.

3.Connect the subwoofer to an AC power source and turn it on (see page 7).

4.Turn on the receiver’s power and access the “speaker setup” or “speaker configuration” menu.

5.Set the subwoofer to “Yes” or “On”.

6.Select the highest possible subwoofer low-pass filter (crossover) frequency allowed by your receiver.

7.Set the main, center and surround speakers’ high-pass filters (crossovers) to an appropriate frequency (see page 18 for a guide).