Page 4
10mm
Installation. • Carefully remove the extractor hood and
the components from the packaging.
• Remove the grease filter ( see page 5).
• Draw a fine vertical line on the wall from
the rear-centre of the hob to the ceiling.
• Draw another line, horizontal this time,
where the bottom edge of the hood
should be. (A minimum distance be-
tween the hob and the hood of 750mm
is recommended.)
• For mounting the 3 chimney brack-
ets, drill 6 holes, 5mm diameter and
45mm deep into the wall as indicated on
the mounting template.
• For mounting the extractor hood, drill
2 holes, 8mm in diameter and 60mm
deep as indicated on the mounting tem-
plate.
• Once all the holes have been drilled the
templates must be removed.
• To attach the chimney mounting brack-
ets push the 5mm wall plugs through
the bracket holes and then insert the
plugs together with the brackets into
the wall holes and fasten securely.
• Push the larger wall plugs into the hood
mounting holes ensuring that they are
flush with the surface.
• Partially screw two 6mm screws into
the wall plugs leaving them to protrude
about 10mm.
CEILING MOUNTING
TEMPLATE
VETICAL LINE FROM
HOB CENTRE TO CEILING
CUT TEMPLATE
ALONG LINE
HORIZONTAL
LINE
750
HOOD MOUNTING
TEMPLATE
• Take the template card and separate the
ceiling mounting template from the hood
mounting template by cutting along the
indicated line.
• Using masking tape, stick the ceiling
mounting template to the wall directly
below the ceiling and centered on the
vertical line.
• In a similar fashion stick the hood mount-
ing template on the wall ensuring that the
centre-lines line up with those drawn on
the wall.
• Lift and hang the extractor hood onto the
two protruding screws through the key-
hole slots provided at the top of the ex-
tractor hood frame.
• Place slotted washers between the ex-
tractor hood frame and the protruding
screw heads
• Align the extractor hood ‘V’ notch with
the vertical centre line and align the body
of the hood with the horizontal line be-
fore tightening the
two screws.