Installing System Components 87
5
Remove the system battery.
a
Support the battery connect or by pressing down firmly on the positive side of the connector.
b
While supporting the battery conn ector , press the battery toward the positive side of the connector and
pry it up out of the securing tabs at the negat ive side of the connector.
Figure 3-24. Replacing the System Battery
NOTICE: To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
6
Install the new system battery.
a
Support the battery connect or by pressing down firmly on the positive side of the connector.
b
Hold the battery with the "+" facing up, and slide it under the securing tabs at the positive side of the
connector.
c
Press the battery straight down into the connector until it snaps into pla ce.
7
If you removed an expans ion card in step 3, replace the card now. See "Installing an Expansion Card" on
page 61.
8
Close the system. See "Opening and Closing the System" on pag e 46.
9
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
10
Enter the System Setup program to confirm that the battery is operating properly. See "Using the System
Setup Program" on page 3 1.
11
Enter the correct time and date in the System Setup program's
Time
and
Date
fields.
12
Exit the System Setup program.
13
To test the newly installed battery, turn off the system and discon nect it from the electrical outlet for at
least an hour.
1 positi ve side of battery
connector 2 system battery 3 negative side of battery
connector
2
3
1