Back to Contents Page
Support Assembly
Dell Studio One 19/1909 Service Manual
Removing the Support Assembly
Replacing the Support Assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the computer stand).
Removing the Support Assembly
1.Follow the instructions in Before You Begin.
2.Remove the hard drive (see Removing the Hard Drive).
3.Remove the power supply unit (see Removing the Power Supply Unit).
4.Remove the optical drive (see Removing the Optical Drive).
5.Remove the side I/O panel (see Removing the Side I/O Panel).
6.Remove the inverter (see Removing the Inverter).
7.Remove the system board (see Removing the System Board).
8.Remove the fourteen screws that secure the support assembly to the LCD panel.
1 | screws (14) | 2 | support assembly |
|
|
|
|
9.Disconnect the following cables from the LCD panel: • LVDS cable from LVDS connector
• touch pad cable from the touch pad connector • touch panel cable from the touch panel module
