Adding and Replacing Parts 107
To replace the hard drive in the hard drive bay:
1Complete the instructions in "Before You Add or Replace Parts" on page100.
2Turn the computer over, and remove the hard drive screws.
NOTICE: When the hard drive is not in the computer, store it in protective antistatic
packaging. See "Protecting Against Electrostatic Discharge" on page17.
3Slide the hard drive out of the computer.
4Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force,
you may damage the connector.
5Insert the drive into the bay, and push the hard drive until it is fully seated in the bay.
6Replace and tighten the screws.
7Use the Operating System CD to install the operating system for your computer (see
page94).
8Use the Drivers and Utilities CD to install the drivers and utilities for your computer
(see page 89).
screws (2)
hard drive