
Installing Memory Riser Boards
NOTICE: System board memory sockets 3 and 4 can either be empty or contain CRIMMs. Sockets 3 and 4 cannot contain RIMMs with memory riser boards installed in sockets 1 and 2.
1If any RIMMs occupy memory sockets on the system board, remove those modules.
NOTE: See "Removing a Memory Module."
To locate the memory sockets on the system board, see "System Board Memory Components."
NOTICE: To avoid damage to the memory riser board, press the riser board straight down into the socket with equal force applied at each end of the riser board.
2Install memory riser board B (see the following figure):
aAlign the slots on the bottom of riser board B with the ridges inside memory socket 2 on the system board.
The memory sockets on the riser board will face away from the microprocessor(s).
bPress riser board B straight down into socket 2 until the securing clips snap into place at the ends of the riser board.
3Install memory riser board A:
a Align the edges of riser board A with the retention brackets on riser board B.
bAlign the slots on the bottom of riser board A with the ridges inside memory socket 1 on the system board.
The memory sockets on the riser board will face away from the microprocessor(s).
cPress riser board A straight down into socket 1 until the securing clips snap into place at the ends of the riser board.
4Install the memory riser board retention bracket:
a Lower the bracket to the chassis so that the two bracket tabs insert into the chassis slots.
b Press the bracket straight down until it is secured in the chassis.
Memory Riser Board Replacement
19