Back to Contents Page

Display Assembly and Display Latch

Dell™ Inspiron™ 600m Service Manual

Display Assembly

Display Bezel

Display Panel

Display Latch

Display Assembly

CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: You must remove the display assembly before you remove the palm rest.

1.Follow the instructions in "Preparing to Work Inside the Computer."

2.Remove the keyboard.

3.Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.

4.Loosen the captive screw that secures the display cable to the system board, and release the cable from the four cable-routing clips.

1display

2cable-routing clips (4)

3display cable connector

5.Pull up on the pull-tab that is attached to the display cable connector to remove the connector from the system board.

6.Remove the three M2.5 x 6-mm screws.

7.Rotate the display assembly to a 90-degree angle, and lift the display assembly up and out of the computer base.

Page 11
Image 11
Dell 600m manual Display Assembly and Display Latch