4Connect the DC power cables to the following components:lane-width PCI-Express expansion slot.–Slot 2 is a x1 lane-width PCI-Express expansion slot.–Slots 3 and 4 are 3.3-V, 64-bit, 133-MHz PCI-X expansion slots.
•POWER CONN connector on the backplane board (if applicable)
•PWR_CONN and 12V connectors on the system board
•Hard drives or SAS backplane.•Diskette drive (if applicable)
•Optical drive (if applicable)
•Tape backup drive (if applicable)
5Close the system. See "Closing the System" on page 47.6Stand the system upright.
7Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Expansion Cards
Your system supports up to five
–Slot 5 is a
NOTICE: If you install a RAC card, it must be installed in PCI slot SLOT_5.
Installing System Components |
| 71 |
|