AShortcut Key 1 (Preset Modes)
BShortcut Key 2 (Brightness/Contrast)
CShortcut Key 3 (Input Source)
DMenu
EExit
FPower On/Off
4.Carefully inspect the screen for abnormalities.
5.Touch the D control on the front panel again. The color of the screen changes to red.
6.Inspect the display for any abnormalities.
7.Repeat steps 5 and 6 to inspect the display in green, blue, and white colored screens.
The test is complete when the white screen appears. To exit, touch the D control again.
If you do not detect any screen abnormalities upon using the
Common Problems
The following table contains general information about common monitor problems you might encounter and the possible solutions.
Common Symptoms | What You Experience |
| Possible Solutions |
No Video/Power LED off | No picture | • | Ensure that the video cable connecting the monitor |
|
|
| and the computer is properly connected and secure. |
|
| • | Verify that the power outlet is functioning properly by |
|
|
| using any other electrical equipment. |
|
| • | Ensure that the power control is depressed fully. |
|
|
|
|
No Video/Power LED on | No picture or no brightness | • | Increase brightness & contrast controls using the |
|
|
| OSD. |
|
| • | Perform monitor |
|
| • | Check for bent or broken pins in the video cable |
|
|
| connector. |
|
| • | Run the |
|
|
|
|
Poor Focus | Picture is fuzzy, blurry, or ghosting | • | Eliminate video extension cables. |
|
| • | Reset the monitor to Factory Settings. |
|
| • | Change the video resolution to the correct aspect |
|
|
| ratio (16:9). |
|
|
|
|
Shaky/Jittery Video | Wavy picture or fine movement | • | Reset the monitor to Factory Settings. |
|
| • | Check environmental factors. |
|
| • | Relocate the monitor and test it in another room. |
|
|
|
|
Missing Pixels | LCD screen has spots | • | Cycle power |
|
| • | Pixel that is permanently off is a natural defect that |
|
|
| can occur in LCD technology. |
|
| • | Run the |
|
|
|
|
LCD screen has bright spots | • | Cycle power | |
|
| • | Pixel that is permanently off is a natural defect that |
|
|
| can occur in LCD technology. |
|
| • | Run the |
|
|
|
|
Brightness Problems | Picture too dim or too bright | • | Reset the monitor to Factory Settings. |
|
| • | Adjust brightness & contrast controls using the OSD. |
|
|
|
|