8.Pull up on the pull-tab to disconnect the display cable from the system board.

9.Remove the two M2 x 6-mm screws from the left and right hinges.

10.Lift the display away from the computer and lay it aside.

1M2 x 6-mm screws (2)

2display cable

3system board connector

Replacing the Display Assembly

1.Align the display assembly over the screw holes in the base of the computer.

2.Replace the screws taken from the left and right hinges.

3.Reconnect the display cable to the system board.

4.Route and connect the antenna cables to the Mini PCI card.

5.Replace the metal shield:

a.Slide the metal shield into place.

b.Tighten the two captive screws that secure the metal shield.

6.Replace the keyboard.

7.Replace the center control cover.

Page 12
Image 12
Dell D410 manual Replacing the Display Assembly