3. Remove the filler bracket (if applicable).
4. Align the PS/2 serial-port adapter bracket in the retention slot and press down firmly. Ensure that the adapter is fully seated in the slot.
Before you close the card retention mechanism, ensure that:
lThe tops of all adapters and filler brackets are flush with the alignment bar.
lThe notch in the top of the adapter or filler bracket fits around the alignment guide.
lClose the card retention latch and gently press until it snaps into place.
6. Connect the adapter cable to the serial port adapter connector (PS2/SER2) on the system board (see System Board Components for connector
locations).
7. Replace the computer cover (see Replacing the Computer Cover).
Removing a PS/2 Serial Port Adapter
1
card retention latch
2
alignment guide
NOTE: See the documentation that came with the PS/2 serial port adapter for information on configuring the adapter, making internal connections, or
customizing it for your computer.
1
fully seated card
not fully seated card
3
bracket within slot
4
bracket caught outside of slot
NOTICE: Do not route cables over any installed cards. Cables routed over the cards can prevent the computer cover from closing properly or cause
damage to the equipment.
NOTE: See the documentation for the PS/2 serial port adapter for information about the cable connections.