Clearing Forgotten Passwords
1. Follow the procedures in Before You Begin.
2. If clearing the password on a small form factor computer, remove the hard drive (see Drives).
3. Locate the 2-pin password jumper (PSWD) on the system board, and remove the jumper to clear the password (see Jumper Settings).
4. If clearing the password on a small form factor computer, install the hard drive (see Drives).
5. Replace the computer cover (see Replacing the Computer Cover).
6. Connect your computer and monitor to electrical outlets, and turn them on.
7. After the Microsoft®Windows®desktop appears on your computer, shut down your computer. (see Turning Off Your Computer)
8. Turn off the monitor and disconnect it from the electrical outlet.
9. Disconnect the computer power cable from the electrical outlet, and press the power button to ground the system board.
10. Open the computer cover (see Removing the Computer Cover for mini tower computers, Removing the Computer Cover for desktop computers and
Removing the Computer Cover for small form factor computers).
11. Remove the hard drive (Removing a Hard Drive).
12. Locate the 2-pin password jumper on the system board and attach the jumper to reenable the password feature.
13. Replace the hard drive (Installing a Hard Drive).
14. Replace the computer cover (see Replacing the Computer Cover).
Jumper
Setting
Description
PSWD
Password features are enabled (default setting).
Password features are disabled.
jumpered unjumpered
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: This process erases both the system and administrator passwords.