Figure 27. Removing and Installing the Expansion-Card Riser 1
1. expansion-card riser 1 cage 2. expansion-card connector
3. expansion card 4. expansion-card latches (2)
Installing expansion card into the expansion-card riser 1
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You can use the expansion-card riser 1 only when both the processors are installed.
1. Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
3. Install the system cover.
4. Remove the expansion-card riser.
5. Press tab A and rotate the latch clockwise.
6. Press tab B and rotate the latch down.
7. Holding the card by its edges, position the card so that the card-edge connector aligns with the
expansion-card connector.
8. Insert the card-edge connector firmly into the expansion-card connector until the card is fully
seated.
61