68 Removing and Installing Parts
NOTICE: To avoid damage to the memory module, press the module straight down into the connector
while you apply equal force to each end of the module.
4
Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the
module.
5
Replace the computer cover. See "Replacing the Computer Cover" on page96.
NOTICE: To connect a network cable, first plug the cable into the network port or device, and then plug
it into the computer.
6
Connect your computer and devices to electrical outlets, and turn them on
7
When a message appears stating that memory size has changed, press <F1> to continue.
8
Log on to your computer.
9
Right-click the
My Computer
icon and click
Properties
.
10
Click the
General
tab.
11
To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Removing Memory CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity
from your body before you touch any of your computer’s electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
1
Follow the procedures in "Before You Begin" on page57.
2
Press out the securing clip at each end of the memory module connector.
3
Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from
the connector.