Back to Removing and Replacing Parts
Processor Fan
Dell™Latitude™E6410/E6410ATGServiceManual

Removing the Processor Fan

1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Remove the battery.
4. Remove the access panel.
5. Disconnect the processor fan cable from the system board.
6. Remove the screws that secure the processor fan onto the heat sink.
7. Remove the processor fan from the computer.

Replacing the Processor Fan

To replace the processor fan, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.