Back to Removing and Replacing Parts
Modem Connector
Dell™Latitude™E6410/E6410ATGServiceManual

Removing the Modem Connector

1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Remove the battery.
4. Remove the Memory .
5. Remove the ExpressCard.
6. Remove the optical drive.
7. Remove the hard drive.
8. Remove the hinge covers.
9. Remove the access panel.
10. Remove the LatitudeON™Flash/CMGModule.
11. Remove the WWAN card.
12. Remove the WLAN card.
13. Remove the coin-cell battery.
14. Remove the LED cover.
15. Remove the keyboard.
16. Remove the fingerprint reader.
17. Remove the display assembly.
18. Remove the ExpressCard cage.
19. Remove the palm rest.
20. Remove the system board.
21. Unthread the modem connector cable from the computer.
22. Lift the modem connector out of its slot and remove.

Replacing the Modem Connector

To replace the modem connector, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.