Back to Contents Page
Display Assembly

Dell™XPS™M1330ServiceManual

Removing the Display Assembly
Replacing the Display Assembly
Removing the Display Bezel
Replacing the Display Bezel
Removing the Display Panel
Replacing the Display Panel
Removing the Display Panel Cable
Removing the Display Hinges

Removing the Display Assembly

1. Follow the instructions in Before You Begin.
2. Remove the hinge covers and center control cover (see Hinge Covers and Center Control Cover).
3. Remove the Mini Card cables from the Mini Cards if applicable (see Wireless Mini Cards).
4. Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from their routing guides.
5. Remove the two M2.5 x 5-mm screws labeled "D" from the computer base.
6. Remove the keyboard (see Keyboard).
7. Remove the two M2.5 x 5-mm screws from each side of the display assembly.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.