Dell MD3000I manual Table C-1. MS-DOS Commands

Table C-1. MS-DOS Commands

Command/Parameters	Description
-GET	Saves iSCSI boot configuration settings in the Electrically
	Erasable Programmable Read-Only (EEPROM) to a disk file
	on the selected iSCSI-capable port. You must specify a file
	name with the -FILE parameter.
	NOTE: For security reasons it is recommended that you disable
	Challenge Handshake Authentication Protocol (CHAP) settings
	when using the save command. If you do not disable these
	settings, ensure that you keep the file secure.
-SET	Restores previously saved iSCSI boot configuration settings
	on the selected iSCSI boot-capable port.
	NOTE: For security reasons it is recommended that you disable
	CHAP settings when using the restore command. If you do not
	disable these settings, ensure that you keep the file secure.
	NOTE: This feature may create multiple primary or secondary
	ports. Review the boot priority setting in the firmware setup
	before you reboot the system.
-DEV <MAC	Selects a specific iSCSI Boot-capable adapter in the system.
address>	NOTE: MS-DOS limits the filename to eight characters.
Where MAC address
is Physical address of
the NIC.

72

Replacing Broadcom NIC Configured for BFi