Dell MS6130, MX003 Except version

CONNECTIONS OF THE “MX” INTERFACE TO THE HOST DEVICE

Except version 17

1.Turn off the host system.

2.Connect the MCA to the host device. Connect the “MX” interface to the MCA.

3.Check the AC input requirements of the transformer to make sure the voltage matches the AC outlet. The socket outlet should be near the equipment and easily accessible.

4.Plug the transformer into the side of the MCA and the AC outlet.

5.Power up the host system.

MS6130 with Liberty® RF

Scanner InterfaceTransformer (Transmitter)

“MX” Scanner Interface

MCA

Host System

Figure 2: Connecting the “MX” (through the MCA) to a host device

To maintain compliance with applicable standards, all circuits connected to the unit must meet the requirements for SELV (Safety Extra Low Voltage) according to EN 60950.

Contents

Page Page Page Page Page Page Page Page Transmitter Group: Receiver Group: Except version Version 17 only Note: Page Load Defaults Enter/Exit Program Mode for the Receiver Enter/Exit Program Mode KB Parameter - Keyboard Type KB Parameter – Keyboard Type KB Parameter - Caps Lock Mode KB Parameter - Alt Mode Enable Alt Mode **Disable Alt Mode KB Parameter - Inter Scan Code Delay (AT and PS/2 Modes) ** 800 Microsecond Delay Page Use the MS700i/MS720i scanner to scan the following bar codes Enable RF Low Speed Option Page Page Battery Charge Contacts Reactivation Switch Green and Red LEDs Infrared Object Sensor Output Window Page Stand LED Indicators CHARGE STATE CHARGE LED STATUS How to Recondition Recondition if: Recondition once a week if: Recondition once every two weeks if: Charge State No Red or Green Red Flash; Green Flash; Steady Red Steady Red; Green Flash Repetitive Red Flashes One Beep Razzberry Tone Two Beeps Three Beeps Page Page Page Specifications Page Page Default Settings of the MS6130 and “MX” Receiver Page Page Page MX003 Series Scanner Interface Pin Assignments Warranty and Disclaimer Limited Warranty North America Headquarters Germany Notices Patents