Back to Contents Page
Camera Module

Dell™Inspiron™N4010ServiceManual

Removing the Camera Module
Replacing the Camera Module

Removing the Camera Module

1. Follow the instructions in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Follow the instructions from step 3 to step 4 in Removing the Optical Drive.
4. Remove the module cover (see Removing the Module Cover).
5. Remove the memory module(s) (see Removing the Memory Module(s)).
6. Remove the keyboard (see Removing the Keyboard).
7. Remove the palm rest (see Removing the Palm Rest).
8. Remove the display assembly (see Removing the Display Assembly).
9. Remove the display bezel (see Removing the Display Bezel).
10. Remove the display panel (see Removing the Display Panel).
11. Peel the camera module from the display cover.
12. Lift the camera module and turn it over.
13. Remove the tape that secures the camera cable to the connector on the camera module.
14. Disconnect the camera cable from the connector on the camera module.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
camera module
2
display cover
3
tape