Dell PPX manual 127,&KHQWDNLQJWKHFRPSXWHUIURPORZWHPSHUDWXUHFRQGLWLRQV

Models: PPX

1 82
Download 82 pages 8.62 Kb
Page 11
Image 11
127,&(￿￿:KHQ￿WDNLQJ￿WKH￿FRPSXWHU￿IURP￿ORZ￿WHPSHUDWXUH￿FRQGLWLRQV￿

86EFPeb0.fm Page 8 Monday, January 24, 2000 12:52 PM

When traveling with the hard-disk drive removed from the computer, wrap the drive in a nonconducting material, such as cloth or paper. If you have the drive

checked by hand, be ready to install the drive in the computer. You can put the hard-disk drive through an X-ray security machine, but never put the drive through a metal detector.

When traveling, do not place the computer in overhead storage compartments where it could slide around. Do not drop your computer or subject it to other mechanical shocks.

Protect your computer, battery, and hard-disk drive from environmental hazards such as dirt, dust, food, liquids, temperature extremes, and overexposure to sunlight.

When you move your computer between environments with very different tem- perature and/or humidity ranges, condensation may form on or within the computer. To avoid damaging the computer, allow sufficient time for the moisture to evaporate before using the computer.

127,&(￿￿:KHQ￿WDNLQJ￿WKH￿FRPSXWHU￿IURP￿ORZ￿WHPSHUDWXUH￿FRQGLWLRQV￿

LQWR￿D￿ZDUPHU￿HQYLURQPHQW￿RU￿IURP￿KLJK￿WHPSHUDWXUH￿FRQGLWLRQV￿LQWR￿D￿ FRROHU￿HQYLURQPHQW￿￿DOORZ￿WKH￿FRPSXWHU￿WR￿DFFOLPDWH￿WR￿URRP￿WHPSHUD￿ WXUH￿EHIRUH￿WXUQLQJ￿RQ￿SRZHU￿

When you disconnect a cable, pull on its connector or on its strain-relief loop, not on the cable itself. As you pull out the connector, keep it evenly aligned to avoid bending any connector pins. Also, before you connect a cable make sure both connectors are correctly oriented and aligned.

Handle components with care. Hold a component such as a memory module by its edges, not its pins.

When removing a memory module from the system board or disconnecting a peripheral device from the computer, wait 5 seconds after turning off the com- puter before removing the memory module or disconnecting the device to help avoid possible damage to the system board.

Before you clean your computer, turn it off, unplug it from its power source, and remove the battery pack(s).

Clean your computer with a soft cloth dampened with water rather than with liquid or aerosol cleaners.

Clean the display with a soft, clean cloth and commercial window cleaner that does not contain wax or abrasives. Apply the cleaner to the cloth; then stroke the cloth across the display in one direction, moving from the top of the display to the bottom. If the display contains grease or some other contaminant, use isopropyl alcohol instead of commercial window cleaner .

If the touch pad becomes smudged from use, it can be cleaned using a soft, clean cloth slightly dampened with water. Always turn off the computer before cleaning the touch pad. To clean the touch pad, stroke the cloth gently across the surface of the touch pad. Do not allow water from the cloth to seep between the touch pad and the top cover of the computer.

If your computer gets wet or is damaged, follow the procedures described in

“Troubleshooting Your Computer” in the User’s Guide . If, after following these

1-8 Dell Latitude System Information

Page 11
Image 11
Dell PPX manual 127,&KHQWDNLQJWKHFRPSXWHUIURPORZWHPSHUDWXUHFRQGLWLRQV