Dell SP2008WFPF appendix Using the OSD Menu

or

The Menu button is used to open and exit the on-screen display (OSD), and exit from menus and sub-menus. See Using the OSD Menu.

OSD menu / select

Use these buttons to adjust (decrease/increase ranges) items in the OSD menu.

Down (-) and Up (+)

Use this button to launch Brightness menu.

Brightness Menu

Use this button to activate automatic setup and adjustment. The following dialog appears on a black screen as the monitor self-adjusts to the current input:

Auto Adjust Auto Adjust In Progress

Auto Adjustment button allows the monitor to self-adjust to the incoming video signal. After using Auto Adjustment, you can further tune your monitor by using the Pixel Clock (Coarse), Phase (Fine) controls in the OSD.

NOTE: Auto Adjust does not occur if you press the button while there are no active video input signals or attached cables.

Use the power button to turn the monitor on and off.

The blue light indicates the monitor is on and fully functional. An amber light indicates power save mode.

Power Button and Indicator

Using the OSD Menu

NOTE: If you change the settings and then either proceed to another menu, or exit the OSD menu, the monitor automatically saves those changes. The changes are also saved if you change the settings and then wait for the OSD menu to disappear.

1. Press the Menu button to open the OSD menu and display the main menu.

Main Menu for Auto Detect Analog (VGA) Input Main Menu for Auto Detect Digital (DVI) Input