R | Figure 6 |
|
G
R
|
| Adhesive |
| |
|
| side |
| |
| G |
|
|
|
|
|
| Figure 7 | |
4 cm | 3 cm |
| A |
|
|
|
|
| |
| R | S | 3 cm | min |
FASTENING THE COOKTOP
Each cooktop is provided with an instal- lation kit including brackets and screws for fastening the cooktop to benches from 30 to 40 mm thick.The kit includes four R
brackets and four
–Cut the unit according to the dimen- sions in figs. 3, 4.
–Turn the hob upside down and rest the glass side on a soft surface.
–Spread the seal G around the edge of the hob (fig. 6).
–Fasten the brackets R to the appropri- ate socket holes, without tightening the screws S for the moment.
Make sure that the tabs are mounted correctly, as shown. Rotate the tabs so that the cooktop can be put into the cutout.
–Put the cooktop into the cutout and po- sition it correctly.
–Put the brackets R into place; tooth A of
the brackets should go into the hole (Fig. 7).
–Tighten screws S until the cooktop is completely secured to the bench.
–Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the cooktop. Take care not to damage the workbench.
8
