GAS SUPPLY:
■This appliance is suitable for use with Natural Gas or ULPG. (Check the “gas type” sticker attached to the appliance).
■For Natural Gas the gas supply must be regulated to obtain a pressure of 1 kPa with al l the burners operating.
■For ULPG models connect the gas supply directly to the appliance test
point adaptor (supplied with the conversion kit) and ensure that the supply pres- sure is regulated to 2.75 kPa.
■Do NOT force the ”elbow“ rotation prior to loosening nut.
■Do NOT over tighten the nut at the ”elbow“.
1.After connecting the gas supply, check the piping and connections for leaks using a soap and water solution. The presence of bubbles indicates a leak, tight- en or replace connections as appropriate.
Warning: Do not use any naked flame to check for leaks.
2.The operation of the appliance MUST be tested before leaving.
3.Adjust the test point pressure or supply pressure to the value which is appropri- ate for the gas type.
4.Turn on the appliance gas controls and light each burner. Check for a well defined blue flame without any yellow tipping. If any abnormality is evident then check that the burner cap is located properly and the injector nipple is aligned correctly.
Figure 8 | Figure 9 |
Gas connection for | |
| NATURAL GAS |
| Gas inlet pipe |
| Gasket |
Test | Brass conical adaptor |
point | (Thread tight: use |
| suitable seal) |
| Gas regulator |
Gas connection for |
ULPG |
Gas inlet pipe |
Gasket |
Brass conical adaptor |
(Thread tight: use |
suitable seal) |
Test point adaptor |
Test |
point |
9 |
