DeLonghi DEDW97FI Using Your Dishwasher, Forgetto Add A Dish?, Atthe End Ofthewash Cycle, Page

Models: DEDW97FI

1 16
Download 16 pages 48.12 Kb
Page 9
Image 9
Using Your Dishwasher

Using Your Dishwasher

Installation

FORGETTO ADD A DISH?

A forgotten dish can be added at any time before the detergent cup opens.

1.Open the door a little to stop the washing.

2.After the spray arms stop working, you can open the door completely.

3.Load the forgotten dishes.

4.Close the door, the dishwasher will start running again after 10 seconds.

WARNING! It is dangerous to open the door when washing, because the hot water may scald you.

ATTHE END OFTHEWASH CYCLE

Switch off the Dishwasher

When the working cycle has finished, the buzzer will sound for 8 seconds to notify you that the program has ended. Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better.

1.Open the door and switch off the dishwasher by pressing the ON/OFF button.

2.Turn off the water tap!

Open the door carefully

The dishes should be allowed to cool down for around 15 minutes before removing from the appliance.

Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. Dishes will be cooler and the drying will be improved.

Unloading the Dishwasher

It is normal that the dishwasher is wet inside.

Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto the dishes in the lower one.

ŸInstall the hook on the aesthetic fascia panel and put the hook into the slot of the outer door of dishwasher (see below).

Top Hook

ST4 countersunk head screw

Lower hook

ŸAfter positioning of the panel, fix the panel onto the outer door using screws and bolts (See following diagrams).

4 x 18 screw

Cover

Spacer for aesthetic panel

Tension adjustment of the door

ŸThe door springs are set at the factory to the proper tension for the outer door. If an aesthetic fascia panel is installed, you will have to adjust the door spring tension. Rotate the adjusting screw to drive the adjustor to strain or relax the steel cable (see below).

ŸAdjust the door spring tension until the door remains horizontal and balanced in the fully- opened position, yet rises to a close with the slight lift of a finger.

relax

Outer door of dishwasher

ST4 screw

Hook for aesthetic panel

Aesthetic panel

Page 24

Page 9

Page 9
Image 9
DeLonghi DEDW97FI Using Your Dishwasher, Forgetto Add A Dish?, Atthe End Ofthewash Cycle, Switch off the Dishwasher, Page