LIGHTING GAS BURNERS
■Check that the electricity is switched on to allow spark ignition.
■Make sure that all controls are turned to zero.
■The gas flow to the burner is controlled by the knobs on the safety taps.
■You control the flow by turning the knob indicator to line up with the following symbols:
– Symbol | : | tap closed (burner off) |
– Symbol | : | High (maximum) |
– Symbol | : | Low (minimum) |
■To ignite automatically, simply push the required knob down and turn it to max- imum, keep the knob down until the burner light.
■You can control the temperature by the knob to “High” from “Minimum”.
■To switch off, turn the knob clockwise until you hear the safety click.
■Note that, if you are using a burner at the minimum setting, you turn the knob clockwise past the maximum setting before reaching the off position.
■Whenever lighting any of the burners produces an abnormal flame, switch that burner off and relight using the minimum setting.
■If after relighting the burner, the flame is still abnormal, turn the burner off and contact our Customer Service Centre to obtain the nearest Authorised Delonghi Service Agent.
■In the case of a mains failure light the burner with a match or lighted taper.
■Note: When the cooker top is not being used, set the gas knobs to their closed positions and also close the cock valve on the gas bottle or the main gas supply line.
Figure 12a | Figure 12b |
mod. DEGH60ST - DEGH60WT | mod. DEGH60 |
15
