Lighting the burners
WITH ELECTRIC IGNITION (without safety
To light one of the burners, press and turn the corresponding knob to the maximum flow position (large flame) and keep the knob pressed down until the gas is lit.
Turn the gas tap to the position required.
Whenever lighting any of the burners produces an abnormal flame, switch that burner off and relight using the minimum setting.
If after relighting the burner, the flame is still abnormal, turn the burner off and contact our Customer Service Centre to obtain the nearest Authorised Delonghi Service Agent.
Lighting the burners
WITH ELECTRIC IGNITION (fitted with safety
In order to light the burner, you must:
1 – Turn the knob in an
2 – Wait for about ten seconds after the gas burner has been lit before letting go of the knob (valve activation delay).
3 – Adjust the gas valve to the desired position.
Important
■If the burner flame should go out, the safety valve will automatically stop the gas flow.
■To 
position, wait for at least 1 minute and then repeat the lighting procedure.
■N.B. If your local gas supply makes it difficult to light the burner with the knob set to maximum, set the knob to minimum and repeat the operation.
■Whenever lighting any of the burners produces an abnormal flame, switch that burner off and relight using the minimum setting.
■If after relighting the burner, the flame is still abnormal, turn the burner off and contact our Customer Service Centre to obtain the nearest Authorised Delonghi Service Agent.
16
