Delphi SA10085 manual Removing swivel mount from your dashboard, Attach car mount to back

Caution: Never use a commercial heat gun or paint-stripping gun. This could result in damage to the unit or to your vehicle.

To vehicle dashboard

adhere to the vehicle’s surface. Make sure you accurately place the pad on the first try since in many cases it will bond almost immediately. 3M recommends a 72-hour curing time for maximum adhesion.

3. Clip the Roady2 onto the swivel or vent mount (figure 7).

4. Reassemble the system as in step 1, inserting cassette audio adaptor

into the vehicle’s cassette deck and the

12V power adaptor into the cigarette lighter.

5.Attach the antenna as explained on page 22 and route the antenna cable as described

on page 24.	Figure 7. Attach car mount to back of
	Roady2 as shown.

Removing swivel mount from your dashboard

You can remove the swivel mount from your dashboard by taking the following steps:

1.Lift one edge of the adhesive pad gently with fingers or the rounded edge of a spoon. Once enough of the edge is loosened to grip with your fingers, pull the pad gently from the mounting surface at a 90-degree angle. Avoid using sharp tools that could damage the vehicle’s interior.

2.If the pad fails to loosen, first warm it with a hair dryer for 2 to 3 minutes to soften the adhesive. Be careful not to apply too much heat, which could damage the mounting surface.

3.If any adhesive remains on the dashboard surface, the adhesive can easily be removed by rubbing your thumb or

finger across it.

4.As necessary, use a mild household cleaner to clean the dashboard surface.

21

Section 5