Installing Drive Belt | Delta 36-714 instruction

INSTALLING DRIVE BELT

DISCONNECT MACHINE FROM

POWER SOURCE.

First, lift motor and remove foam packing block from around motor.

While lifting motor (A) Fig. 8, place a 10-12 inch long piece of 2x4, or another similar thickness of wood, (B) Fig. 8 as shown. This will help prop up the motor and will make it easier to install the grooved belt, (C) Fig. 8A.

Place grooved belt (C) Fig. 8A in grooved pulley located behind the motor (shown in Fig. 8B) and the one directly above, located on the opposite end of the blade arbor. Ensure that the grooves of the belt completely make contact with the grooves in these pulleys.

Carefully lift motor and remove the block of wood. The weight of the motor will provide the correct tension on the belt.

The belt (D) Fig. 8D is shown installed correctly as seen through the open door in the side of the saw.

A

Fig. 8

C

Fig. 8A

Fig. 8B

D

Fig. 8D

B

11

Image 11

Delta 36-714 instruction manual Installing Drive Belt

Contents

Delta 10 Hybrid Saw Important Safety Instructions Table of Contents California Proposition Safety Guidelines Definitions Stay ALERT, Watch What YOU are DOING, General Safety RulesImportant Safety Instructions Cutting the Workpiece Without the USE Additional Safety Rules for Table Saws Grounding Instructions Power ConnectionsMotor Specifications Foreword Functional DescriptionExtension Cords Carton Contents Assembly Tools Required AssemblyUnpacking and Cleaning Blade Tilting and Raising Handwheels Disconnect Machine from Power SourceBolting the SAW to Floor Installing Drive Belt Extension Wings S C O N N E C T M a C H I N E F R O M Power SourceDo not Operate the SAW Without Right Table Wing Installed Installing the Switch Installing Your Fence System Assembling Blade Guard and Splitter Assembly If alignment is necessary, loosen the two screws Aligning Splitter with Blade SAW Blade Installing Dust Port Installing Table InsertAdjusting Table Insert Installing Tool Holders Starting and Stopping SAW Locking Switch in OFF PositionOperation Assembling Miter Gage Blade Alignment Checking Blade Alignment Backlash Adjustments Adjusting Blade Alignment Common Sawing Operations Miter Gage Operation and Adjustment CROSS-CUTTING Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING Guard Removed for CLARITY. Always USE the Guard RippingConstructing a Push Stick Using Moulding Cutterhead Using Auxiliary Wood Facing on RIP Fence Using Dado Head Constructing a Featherboard TroubleshootingPower Tool Institute Constructing a Push Stick Pushstick Service Maintenance Warranty AccessoriesPage Page Canadian PORTER-CABLE Delta Service Centers