Delta 36-714 Extension Wings, S C O N N E C T M a C H I N E F R O M Power Source

EXTENSION WINGS

D I S C O N N E C T M A C H I N E F R O M

POWER SOURCE.

Assemble left extension wing (A) Fig. 10A to the saw table. Align the three holes in the extension wing with the three holes (A) Fig. 9 in the side of the saw table. Place a 7/16" lockwasher, then a 7/16" flat washer on a 7/16- 20x1-1/4” hex head screw (all shown at (B) Fig. 9). Insert the screw through the hole in the extension wing and thread the screw into the tapped hole in the side of the table. Repeat this process for the two remaining holes in the extension wing and saw table.

With a straight edge (E) Fig. 10A, make certain the extension wing (A) is level with the saw table before tightening three bolts (B) Fig. 10 with an 18mm open end wrench. Starting with a bolt on one side, make sure the tables are lined up and then tighten that bolt. Then, move to the middle bolt and follow the same procedure of aligning and tightening. Then do the same for the bolt on the other end.

NOTE: MAKE SURE FRONT EDGE OF WING IS FLUSH TO OR SLIGHTLY BEHIND THE FRONT EDGE OF THE TABLE.

Place the right extension wing on the other side of the saw in the same manner.

DO NOT OPERATE THE SAW WITHOUT RIGHT TABLE WING INSTALLED.

12

B

A

Fig. 9

B

Fig. 10

E

A

Fig. 10A