B
A
Fig. 68
Fig. 69
6.Use an outboard tool rest (B) Fig. 68 for all outboard turnings.
7.Fig. 69 illustrates the correct method for outboard turnings.
MAINTENANCE
A
Fig. 70
C
B
A 
Fig. 71
REPLACING DRIVE BELT
1.Use the supplied hex wrench (A) Fig. 70 to loosen the set screw in the handwheel (B) Fig. 70. Engage the spindle lock (C) and rotate the handwheel clockwise to remove.
2.Use an 11/16" wrench to remove the bolt (A) Fig. 71 from the motor yoke.
C 
B
A
Fig. 72
Fig. 73
3.While holding the motor (A) Fig. 72 with one hand, use an 11/16” wrench (B) to remove the bolt (C). Lift the motor
(A) and remove the belt from the motor pulley.
4.Pull the motor (A) Fig. 72 out, take it to the back of the lathe, and place it on the lathe bed (Fig. 73).
21
