ATTACHING TOP FILTER BAGS
DISCONNECT MACHINE FROM POWER SOURCE
NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP.
1.Assemble upper (A) and lower (B) bag hanging rods as shown in Fig. 11.
2.Place 3/8” flat washer on 5/16”x1 1/4” hex head screw. Insert the screw through hole in center of bag hanging assembly (A) Fig. 12 and Fig. 12A and through the hole in the upper bag hanging rod (B) Fig. 12. Then place another large 5/16” flat washer on end of screw followed by a 5/16 hex nut. Assem- bly shown complete in Fig. 12. Tighten all securely with 12mm wrench.
3.Hang bag loops (C) Fig. 12A around hooks on bag hanging assembly (B), as shown in Fig. 12A
4.Insert rod (A) Fig. 12B into hole in bracket (B). Make sure the four bag ends are not twisted.
5.Work open end of filter bag into top groove of dust collector drum until secure and sealed. (Similar to how internal ring of bottom bag was inserted, Fig. 9. It will be necessary to bend and fold the internal bag retainer ring to fit it into place.
6.Fig. 12C shows the bags installed properly.
7.Repeat steps for the other bag.
Fig. 12C
A
B
Fig. 11
A
B
Fig. 12
A
C
B
Fig. 12A
A
B 
Fig. 12B
12
