Delta 491836-00, SM500 warranty Functional Description, Extension Cords, R E W O R D

EXTENSION CORDS

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord which has a 3-prong grounding type plug and matching receptacle which will accept the machine’s plug. When using an extension cord, be sure to use one heavy enough to carry the current of the machine. An undersized cord will cause a drop in line voltage, resulting in loss of power and overheating. Fig. C shows the correct gauge to use depending on the cord length. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the cord.

MINIMUM GAUGE EXTENSION CORD

RECOMMENDED SIZES FOR USE WITH STAT I O N A RY ELECTRIC MACHINES

A m p e re		Total Length	Gauge of
R a t i n g	Vo l t s	of Cord in Feet	Extension Cord
0 - 6	1 2 0	up to 2 5	18 AW G
0 - 6	1 2 0	2 5 - 5 0	16 AW G
0 - 6	1 2 0	5 0 - 1 0 0	16 AW G
0 - 6	1 2 0	1 0 0 - 1 5 0	14 AW G
6 - 1 0	1 2 0	up to 2 5	18 AW G
6 - 1 0	1 2 0	2 5 - 5 0	16 AW G
6 - 1 0	1 2 0	5 0 - 1 0 0	14 AW G
6 - 1 0	1 2 0	1 0 0 - 1 5 0	12 AWG
1 0 - 1 2	1 2 0	up to 2 5	16 AW G
1 0 - 1 2	1 2 0	2 5 - 5 0	16 AW G
1 0 - 1 2	1 2 0	5 0 - 1 0 0	14 AW G
1 0 - 1 2	1 2 0	1 0 0 - 1 5 0	12 AW G
1 2 - 1 6	1 2 0	up to 2 5	14 AW G
1 2 - 1 6	1 2 0	2 5 - 5 0	12 AW G
1 2 - 1 6	1 2 0	GREATER THAN 50 FEET NOT RECOMMENDED

Fig. C

FUNCTIONAL DESCRIPTION

F O R E W O R D

The ShopMaster Model SM500 is a 4" Belt, 6" Disc Sander that comes equipped with a 5.2 AMP 120 Volt Single Phase Induction Motor, a tilting table, a miter gauge, a backstop, a 4" x 36" 60-grit sanding belt, and a 6" 60-grit sanding disc. You can mount the tilting table for use on either the belt or disc unit, and can operate the belt in the horizontal position, the vertical position, or any position in between.

NOTICE: The photo on the manual cover illustrates the current production model. All other illustrations contained in the manual are representative only and may not depict the actual color, labeling, or accessories, and are intended to illustrate technique only.

7