2.Fasten cutterhead raising and lowering handle (A) Fig. 8, to shaft using the M5x.8x20mm hex socket head screw (C) with wrench supplied.
3.Rotate handle (A) to the operating position as shown in Fig. 9, and tighten set screw (D).
FASTENING PLANER TO STAND
Place the planer on the stand and align the four holes in the base of the machine, two of which are shown at (A) Fig. 10, with the four holes in the top of the stand. Place the M8x1.25x35mm hex head flange bolt through the holes in the planer and the stand, and thread the M8x1.25 flange nut onto the hex head flange bolt and tighten securely. Only operate planer, attached to stand, on a flat level surface.
C
A
Fig. 8
A
D
Fig. 9
A
A
Fig. 10
10
