5.Figure 26 illustrates the cutterhead (C) locked in place allowing access to the knife locking bar (E).
6.Using the supplied wrench (E) Fig. 27, unscrew the six screws, five of which are shown at (F), only enough until locking bar (D) separates from knife, allowing knife to be removed.
7.Insert knife transfer tool (G) Fig. 28, underneath center of knife. Lift the knife transfer tool up until knife
(H) separates from pins (J) and pull out and remove knife as shown. NOTE: Knife transfer tool is magnetized, allowing it to attach to knife.
8.Rotate knife (H) Fig. 29, end-for-end, or using a new knife, position knife transfer tool (G) on top of knife as shown. Place knife in cutterhead with bevel up underneath locking bar (D), making sure pins (J) in cutterhead engage with holes (K) in knife.
D | D |
|
C
E
Fig. 26
E
F
F
D
Fig. 27
G
J
H
Fig. 28
D
K
J
K
J
H
G
Fig. 29
15
