PLANER PARTS
1- 12½" Portable Planer
2- Cutterhead raising and lowering handle
3- M5x.8x20mm hex socket head screw
4- Cutterhead lock handle
5- M6x20mm specia hex socket head screw
6- Wrench and handle assembly
7- Knife transfer tool
1
Fig. 1
4 | 2 | 3 |
5
7
6
Fig. 2
ASSEMBLY
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
STAND
A - Top Brace
B - Bottom brace
C - Leg (4)
D - Rubber feet (4)
E - Carriage bolt M8x1.25x16mm (16)
F - Flange nut M8x1.25 (20)
*- Hex head flange screw M8x1.25x35mm (4) (For fastening planer to stand) * not shown
1.Align the holes in the bottom braces (B) Fig. 3 with the holes in the legs (C), insert a carriage bolt (E) through the leg and the bottom brace, and thread the flange nut
(F) onto the carriage bolt. Repeat this process for the remaining holes in the bottom braces and table legs. Do not completely tighten hardware at this time.
2.Assemble the top braces (A) Fig. 3 to the legs (C) in the same manner as step 1.
3.Insert the rubber feet (D) Fig. 3 onto the end of the legs (C) and tighten all hardware at this time.
E A
F
B
C
D
Fig. 3
8
