LOWERING
EXTENSION TABLES
The infeed and outfeed table extensions (A) Fig. 4, are shipped attached to the machine in the “UP” position. Rotate both table extensions to the down position as shown. The top surface of the table extensions should be level with the planer table. To check and adjust if necessary, refer to the section of this manual entitled
“LEVELING TABLE EXTENSIONS.”
CUTTERHEAD
LOCK HANDLE
1.Assemble the cutterhead lock handle (A) Fig. 5, to shaft (B).
2.Fasten cutterhead lock handle (A) Fig. 6, to the shaft using the M6x20mm special hex socket head screw (C), with wrench supplied.
CUTTERHEAD RAISING AND LOWERING HANDLE
1.Assemble the cutterhead raising and lowering handle
(A) Fig. 7, to shaft (B), making certain flat on shaft is engaged with flat in handle.
A
A
Fig. 4
A
B
Fig. 5
AC
Fig. 6
A
B
Fig. 7
9
