9.Remove knife transfer tool and tighten the six screws, five of which are shown at (F) Fig. 30, using wrench (E) supplied.
10.Replace other knife by rotating head 180 degrees and repeat STEPS 5 THROUGH 10.
11.Replace cutterhead guard (B) Fig. 31, making sure cutterhead lock (D) is depressed and underneath guard as shown. Slide guard in as far as possible and replace two screws, one of which is shown at (A) Fig. 32. These screws were removed in STEP 3.
ADJUSTING HEIGHT OF OUTFEED ROLLER
DISCONNECT MACHINE FROM POWER SOURCE.
1.The outfeed roller is adjusted at the factory to be 0.020" below the cutting circle. In order to check and adjust the outfeed roller, you will need a homemade gage block made of hardwood. This gage block can be constructed by following the dimensions shown in Fig. 33. NOTE: Make sure that the height of the block is exactly 4 ".
E
DF
F
Fig. 30
D
B
Fig. 31
A
Fig. 32
4"
1/ " 4
2" 1/2"3" 4"
Fig. 33
16
