ENGLISH

Getting

Multi-zone

 

 

 

ZONE2 out Connections

 

 

 

Started

 

 

 

If another pre-main (integrated) amplifier is connected, the ZONE2 out connectors can be used to play a

Connections

different program source in ZONE2 at the same time (vpage 54 ~ 57).

Pre-main amplifier

 

 

 

 

 

 

(ZONE2)

 

 

 

"6%*0

 

 

Setup

"6%*0

 

 

 

*/

 

 

 

 

 

 

 

-

3

 

 

Playback

L

R

 

 

ControlRemote

L

R

 

 

Zone-Multi

 

 

 

 

Information

 

 

 

 

Troubleshooting

"69

Input

Output

 

 

065

 

 

 

Extension jack for future use.

 

Infrared

 

Infrared

 

retransmitter

 

sensor

 

NOTE

•For the audio output, use high quality pin-plug cords so that no induction humming or noise is produced.

•For instructions on installing and operating separately sold devices, refer to the respective devices’ operating instructions.

•To conduct multi-zone playback, see“Amp Assign / Multi-zone Connections and Operations” (vpage 54 ~ 57).

External ControllerRS-232C connector

This connector is used for an external controller.

b If you wish to control the AVR-2308CI from an external controller using the RS-232C connector, perform the operation below beforehand.

q Turn on the AVR-2308CI’s power.

w Turn off the AVR-2308CI’s power from the external controller.

e Check that the AVR-2308CI is in the standby mode.

•When using in combination with an RF Remote Controller (RC-7000CI, sold separately) or RF Remote Receiver (RC-7001RCI, sold separately) two-way communication with an RF Remote Controller is possible.

The AVR-2308CI’s status information as well as iPod can be browsed watching the RF Remote Controller’s display. For details, refer to the operating instructions of the respective devices.

•When used in combination with an RF Remote Controller or RF Remote Receiver, make the settings at menu “Manual Setup” – “Option Setup” – “2Way Remote” – “Used” (vpage 32).

Trigger output jack

The power of an external device equipped with a trigger input jack can be turned on and off in association with operations on the AVR-2308CI. For details, see menu “Manual Setup” – “Option Setup” – “Trigger Out” (vpage 32).

• Output: DC 12 V 150 mA MAX.

Check the trigger input conditions of the connected device.

19