Denon AVR-2308CI Remote Control Unit Operations, Main Remote Control Unit, Set, Set, and, [MODE, [MODE, Press, ENGLISH, [NUMBER], [NUMBER], [MAIN ON], Presetting, SELECTOR 1]

Remote Control Unit Operations

Main Remote Control Unit

[Front]

[MODE	[MODE
SELECTOR 1]	SELECTOR 2]

Operating DENON Audio Components1Set [MODE SELECTOR 1] to “AUDIO”.

2Set [MODE SELECTOR 2] to the position for the component to be operated (CD, iPod/NETWORK or TAPE/CD-R/MD).

3Operate the audio component.

b For details, refer to the component’s operating instructions.

b While this remote control is compatible with a wide range of infrared controlled components, it may be the case that some component models cannot be operated with this remote control.

ENGLISH

• The signals for the pressed buttons are emitted while setting the		Getting
	preset memory. To avoid accidental operation, cover the remote
		Started
	control unit’s transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
	cannot be used for some models, even if they are of makes listed in	Connections
	the list of preset codes.
• Some manufacturers use more than one type of remote control code.
	Refer to the included list of preset codes to change the number and
	verify correct operation.
• The preset memory can be set for one component only among the		Setup
	following: TAPE/CD-R/MD, DVD/VDP and SAT/CABLE.
		Playback
	Operating Preset Components
1Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.
		Remote

[Rear]

[ZONE2 OFF] [MAIN ON][NUMBER]

Depending on the model and year of manufacture of your equipment, some buttons may not operate.

Presetting

•DENON and other makes of components can be operated by setting the preset memory.

•This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the manufacturer of the component as shown in the list of preset codes (vEnd of this manual).

•Operation is not possible for some models.

1Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.

b Set to the AUDIO side for the CD or TAPE/CD-R/MD position, and to the VIDEO side for the DVD/VDP, SAT/CABLE, VCR or TV position.

2Set [MODE SELECTOR 2] to the component to be registered.

3Press [ZONE2 OFF] and [MAIN ON] at the same time. The indicator starts flashing.

4Referring to the included list of preset codes, press [NUMBER] to input the preset code (a 3-digit number) for the manufacturer of the component whose signals you want to store in the memory.

5To store the codes of another component in the memory, repeat steps 1 to 4.

b Set to the AUDIO side for the CD or TAPE/CD-R/MD position,	Control
and to the VIDEO side for the DVD/VDP, SAT/CABLE, VCR or TV
position.
	-Multi
Set [MODE SELECTOR 2] to the component you want
2to operate.
	Zone
3Operate the component.
	Information
b For details, refer to the component’s operating instructions.
b Some models cannot be operated with this remote control unit.
	Troubleshooting

50