Denon AVR-2308CI All, OFF, NOTE, Assign, sOption, Room EQ, Error Messages, dParameter Check, Direct Mode Setup, [Selectable items], [Selectable items], [Selectable items]

ENGLISH

Getting	Error Messages
	If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is
Started	displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure over
	again.
Connections
	Error messages (examples)							Cause			Measures
								• Not all speakers could be detected.			• Check the speaker connections.
			Auto Setup					• Included setup microphone is not connected.			• Connect the included setup microphone to the SETUP
					Caution!						MIC jack on the main unit.
		Microphone:None
Setup					or
		Speaker :None
Playback				Retry				• Too much noise in the room	for	accurate	• Either turn off any device generating noise or move it
				Cancel
			Auto Setup					measurements to be made.			away.
Remote					Caution!
											• Try again when the surroundings are quiet.
		Ambient noise is
								• Speaker or subwoofer sound is	too	low for	• Check the speaker installation and the direction in which
		too high or
Control		Level is too low.						accurate measurements to be made.			the speakers are facing.
											• Adjust the subwoofer’s volume.
				Retry
Multi				Cancel
			Auto Setup					• Displayed speaker could not be detected.			• Check the connections of the displayed speaker.
-								· The front L and front R speakers were not
Zone
						Caution!		properly detected.
Information							Front	· Only one channel of the surround speakers
								was detected.
							R :None
					Retry			· Sound was output from the	R	channel
								when only one surround back speaker was
					Cancel
								connected.
					Skip
Troubleshooting								· The surround back, but the surround speaker
								was not detected.
			Auto Setup					• Displayed speaker connected with the polarities			• Check the polarities of the displayed speaker.
								reversed.			• For some speakers, this error message may be displayed
						Caution!					even if the speaker is properly connected. In this case,
							Front				select “Skip”.
							L :Phase
					Retry
					Cancel
					Skip

Select “Retry” to make the measurements again.

NOTE Be sure to turn the power off before checking the speaker connections.

sOption

Select settings for room EQ, mic, etc.

Room EQ

Select room EQ setting method.

[Selectable items]

All : Apply settings to all surround modes.

Assign : Make settings for each surround mode separately.

Direct Mode Setup

Select room EQ use for DIRECT or PURE DIRECT mode.

[Selectable items]

ON : Use room EQ.

OFF : Do not use room EQ.

dParameter Check

Check auto setup measurement results.

This is displayed after the auto setup procedure is completed.

[Selectable items]
Speaker Config. Check	Distance Check
Channel Level Check	Crossover Freq. Check
EQ Check

The auto setup results can be set again when “Restore” is selected.

25