Denon AVR-3300 manual 13LAST FUNCTION MEMORY, 14INITIALIZATION OF THE MICROPROCESSOR

ENGLISH

Recalling preset stations

• To call out out preset stations from the remote control unit.

1	Watching the display, press the
	SHIFT button to select the preset
	memory block.
2	(Remote control unit)
	Watching the display, press the
	PRESET UP or DOWN button to
	select the desired preset channel.

(Remote control unit)

• Calling out preset stations from the main unit‘s panel.

1 TUNING Press the TUNING PRESET button.

PRESET

	START	LEARNED/TX	RC-860
SYSTEM CALL		POWER
SET	CALL	OFF	ON / SOURCE
DVD	VDP	TUNER	SHIFT
1	2	3
TV/DBS		PHONO
4	5	6
VCR-1	CD	MD / TAPE	CHANNEL
7	8	9
VCR-2/V.AUX			TV/VCR
+10	0		A / B
VOLUME			DISC SKIP+
	DOLBY / DTS
SPEAKER	SURROUND	DIRECT
DSP SIMULATION	5CH STEREO	STEREO
			MASTER VOL.
INPUT MODE	ANALOG	EXT.IN
AUDIO	DECK MD
	CD	MULTI	MUTING

AVR/AVC	VIDEO	DVD	TV
		VDP	VCR

	SYSTEM	SURROUND
TUNING	SETUP	PARAMETER
BAND	TITLE	MENU/GUIDE
		CH SELECT
MODE		ENTER
		SELECT
MEMORY	STATUS	ON SCREEN
	DISPLAY	RETURN
USE/LEARN T.TONE	MULTI	OUTPUT SET UP

1

2

(Main unit)

2	Turn the FUNCTION knob and
	select the desired station.

(Main unit)

13LAST FUNCTION MEMORY

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

•The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit’s power switch is off and with the power cord disconnected.

14INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure.

1	Switch off the unit and remove the AC cord from the wall
	outlet. (for North America model)
	Switch off the unit using the main unit‘s power switch. (for
	multiple voltage model)
2	Hold the following AUTO button and PCM button, and plug
	the AC cord into the outlet. (for North America model)

	Hold the following AUTO button and PCM button, and turn
	the main unit‘s power switch on. (for multiple voltage model)
3	Check that the entire display is flashing with an interval of
	about 1 second, and release your fingers from the 2 buttons
	and the microprocessor will be initialized.

1,2 2

NOTES:

•If step 3 does not work, start over from step 1.

•If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment from the factory).

55