Basic Operation
1Either turn <SOURCE SELECT> or press [SAT TU1/2] to select “SIRIUS”.
2Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE CONTROL 2] to “TUNER”.
(vpage 61 “Remote Control Unit Operations”)
3Use TUNING to select the station.
When the station is tuned in, the name of the track and artist are displayed.
•The channel switches continuously when TUNING is pressed and held.
•SIRIUS Radio stations can be preset using the same procedure as for FM/AM stations (vpage 51 “Presetting Radio Stations (Preset Memory)” and “Listening to Preset Stations”).
b You cannot perform “Auto Preset”.
•The track name, artist name, composer name, category and reception level can be checked by pressing <STATUS>.
•The time (default : 30 sec) for which the
–
Press uiop to return to the original screen.
Checking the SIRIUS Signal Strength and Radio ID
1Either turn <SOURCE SELECT> or press [SAT TU1/2] to select “SIRIUS”.
2Press <STATUS> until “SIGNAL” appears on the display.
The display will switch as shown below, depending on the reception conditions.
Display | Status |
EXCELLENT | Signal strength is excellent |
GOOD | Signal strength is good |
WEAK | Signal strength is weak |
NO SIGNAL | No signal |
3Adjust the position of the antenna until “SIGNAL: EXCELLENT” is shown on the display.
4Press <STATUS> until the station you want to check (example: “SR001”) is displayed.
5Press TUNING and select channel 0 (SR000). Channel No. and Sirius ID are alternately shown on the display.
SR000 SiriusID |
| Radio ID | |
************ |
|
| |
|
|
| |
|
|
|
|
bWrite your own SIRIUS ID for storage use. Sirius ID :
The strength of both the SIRIUS and terrestrial signals can be checked at menu “Input Setup” – “Antenna Aiming” (vpage 39).
ENGLISH
Presetting Radio Stations
(Preset Memory)
Your favorite broadcast stations can be preset so that you can tune them in easily. Up to 56 stations can be preset.
1Tune in the broadcast station you want to preset.
2Press [MEMORY].
3Press SHIFT to select the block (A to G) in which the station is to be preset.
4Press <PRESET> or [CHANNEL
5Press [MEMORY] again to complete the setting.
To preset other stations, repeat steps 1 to 5.
NOTE
Preset stations are erased by overwriting them.
Listening to Preset Stations
1Press SHIFT to select the memory block (A to G).
2Press <PRESET> or [CHANNEL
Specifications Troubleshooting Information
54