Denon DN-C635 NOTE :, RS-422A, RS-232C, @0TIME button, !6Pitch Slider, (2) Rear panel, @1TITLE button, @2FOLDER button, !9REPEAT button, @4Headphones jack

!6Pitch Slider	@2FOLDER button
• Use this slider to adjust the play speed. Slide	• When disc containing MP3 format files is
up to decrease the play speed, down to	loaded, in the stop mode press this button then
increase the play speed.	the folder select mode is possible.

(2) Rear panelqBALANCED OUT connectors

• These are active balanced outputs using XLR

ENGLISH

RS-422A

Pin No. Signal Name I / O

!7PROG. PLAY ON/OFF button

•When this button is pressed while the PROG indicator is lit, the program play mode is set.

•The button will not function during the A-B play mode.

•The PROG. PLAY ON/OFF LED lights during the program play standby and play modes.

•When the button is pressed during the program play standby or play mode, the program play mode is cleared.

!8PROGRAM IN button

•Press this button to set the program input mode.

•The button will not function during the play mode.

•The PROG indicator flashes when in the program input mode.

•The PROG indicator lights when a program is set.

!9REPEAT button

• Press this to perform repeat playback.

@0TIME button

•The time display switches each time this button is pressed. (“REMAIN”, “ELAPSED”)

@1TITLE button

•When the button is pressed, the text information (Disc title, track title, disc artist or track artits) is displayed.

•When the button is pressed while in the stop mode with a disc containing an MP3 ID3-Tag loaded, the file name is displayed. When pressed during playback, the display switches as shown below.

Elapsed time of currently playing track

File name of currently playing track

Title name

Artist name

Album name

@3A-B (A-B repeat) button

•Use this to play a set section repeatedly.

•When the button is pressed once during playback, that position is set as the A point and the “A-B” indicator flashes on the display.

•When the button is pressed again, that position is set as the B point, the “A-B” indicator stops flashing (remaining lit), and the A-B section begins playing repeatedly.

•When the button is pressed again, A-B repeat is canceled and the mode returns to the normal play mode.

@4Headphones jack

•For private listening, you can connect your headphones to this jack.

@5PHONES LEVEL control

•Use this adjust the output level of the headphones.

type connections. The CD’s playback signals are output from these connectors.

• Pin layout : 1. Common / 2. Hot / 3. Cold

• Applicable connector :

Cannon XLR-3-31 or equivalent.

NOTE :

•Do not short-circuit the hot or cold pin with the common pin.

wLEVEL L/R controls

•Use these controls to adjust the level of the audio signals from the BALANCED OUT connectors.

eUNBALANCED OUT jacks

•These are unbalanced outputs using RCA type jacks.

rDIGITAL OUT jack

•This is a coaxial output using an RCA type jack.

•Signal format : SPDIF or IEC-958 Type II

tSerial control port

•This is serial remote connector.

•Applicable connector : 9-pin D-sub (male)

•Baud rate : 9600 bps

•Pin layout

RS-232C

Pin No.	Signal Name	I / O
1	GND	_
6	NC	_
2	TxD	O
7	NC	_
3	RxD	I
8	NC	_
4	NC	_
9	NC	_
5	S. GROUND	_

1	GND	_
6	NC	_
2	TxD (RETURN)	O
7	TxD	O
3	RxD	I
8	RxD (RETURN)	I
4	NC	_
9	NC	_
5	S. GROUND	_

yParallel remote control port

•This is a parallel remote connector.

•Applicable connector : 25-pin D-sub (male)

•Connecting signal layout

Pin No.	Signal Name	I / O
1	FG	_
14	PLAY tally	O	TTL (Iol = 20mA)
2	PLAY command	I	HCMOS (Ii = 3mA)
15	PAUSE tally	O	TTL (Iol = 20mA)
3	PAUSE command	I	HCMOS (Ii = 3mA)
16	CUE tally	O	TTL (Iol = 20mA)
4	CUE command	I	HCMOS (Ii = 3mA)
17	INDEX 2/INDEX 3 tally	O	TTL (Iol = 20mA)
5	TRACK (+) command	I	HCMOS (Ii = 3mA)
18	Tally common	_
6	TRACK (–) command	I	HCMOS (Ii = 3mA)
19	Reserved	_
7	SEARCH (Fwd) command	I	HCMOS (Ii = 3mA)
20	Reserved	_
8	SEARCH (Rev) command	I	HCMOS (Ii = 3mA)
21	Reserved	_
9	FADER START command	I	HCMOS (Ii = 3mA)
22	Tally power supply	_	+3.3V, 20mA
10	Command common	_	(Ii = 10mA)
23	Command common	_
11	NC	_
24	EOM tally	_	TTL (Iol = 20mA)
12	Reserved	_
25	Reserved	_
13	Reserved	_

7