ENGLISH
Checking the currently playing program source, etc.
When an operation is performed on the remote control unit, that operation appears on the display, making it possible to check the operation visually.
The set’s operating status can also be checked on the display using the procedure described below.
B
1 Front panel display
•Descriptions of the unit’s operations are also displayed on the front panel display. In addition, the display can be switched to check the unit’s operating status while playing a source by pressing the STATUS button.
STATUS | STATUS |
2
1
2 1
TUNER | PHONO | V. AUX | VCR | DVD / VDP |
| CD |
| PHONO | DVD / VDP |
• |
|
|
|
|
PRESET | CDR / TAPE |
| CD | VCR |
ª |
|
|
|
|
A SPEAKER B | TUNER | CDR / TAPE | V. AUX | |
DIMMER | CH VOL |
| SHIFT |
|
|
| • |
| • |
STATUS |
|
|
|
|
| • | PRESET |
| MASTER VOL |
VIDEO SELECT |
| ª | MUTING | ª |
| ª |
|
|
|
B
REMOTE CONTROL UNIT
(Main unit)(Remote control unit)
2 | Using the dimmer function |
|
• Use this to change the brightness of the display. | ||
| The display brightness changes in four steps (bright, | |
| medium, dim and off) by pressing the main unit’s DIMMER | |
| button repeatedly. |
|
| DIMMER | DIMMER |
| (Main unit) | (Remote control unit) |
The brightness changes in 3 steps each time the button is pressed, and finally the display turns off.
Recording the program source
(recording the source currently being monitored)
1 | Follow steps 1 to 3 under “Playing the program source” |
(page 14). |
Simultaneous recording
2 | Start recording on the tape or video deck. |
For instructions, refer to the component’s operating |
instructions.
The signals of the source selected with the function selector button are output simultaneously to the CDR/TAPE and VCR REC OUT jacks. If a total of two tape and/or video decks are connected and set to the recording mode, the same source can be recorded simultaneously on every decks.
20
