ENGLISH

Operation

FUNCTION

<ZONE/REC SELECT>

<POWER>

<SPEAKER>

FUNCTION

[MODE SELECTOR 1] [MODE SELECTOR 2]

[ZONE2 ON]

[ZONE2 OFF] [ZONE3 ON]

[NUMBER] (0 ~ 9, +10)

[A] [D]

FUNCTION

About the button names in this explanation

<> : Buttons on the main unit

[

] : Buttons on the remote control unit

Button name only :

Buttons on the main unit and remote control unit

Recording (audio and/or video)

1 Press <ZONE/REC SELECT> until “RECOUT” appears on the display.

M-ZONE RECOUT

2 Use FUNCTION to select the source to be recorded (audio and/or video).

• The “ ” indicator lights.

3 Record (the audio or video signals).

For operations, see the operating instructions of the device from which you are recording (audio or video signals).

•To cancel, press <ZONE/REC SELECT> and set the function to “ZONE”.

NOTE:

•When the REC OUT mode is selected, [ZONE2 (ZONE3) ON] and FUNCTION (ZONE) cannot be operated.

Operation

About the memory functions

¢Last function memory

The various settings set when the DRA-397’s power is switched to standby are stored in the memory. When the power is turned back on, the settings made when the power was switched to standby are recalled.

¢Backup memory

The various settings are stored in the memory for about 1 week, even when the power is turned off or the power cord is unplugged.

Initialization of the microprocessor

If the indication on the display is not normal or if the operation of the unit is not correct, then the microprocessor should be reset by the following procedure.

1 Switch off the unit using <POWER>.

2 Keep both <SPEAKER> (A and B) depressed and turn on the unit by pressing <POWER>.

3 Check that the entire display is flashing at 1-second intervals and release the buttons.

•The microprocessor will be initialized.

•If step 3 does not work, start over from step 1.

•If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment from the factory).

19

ENGLISH